Suzuki RMX450Z - Rear Shock Absorber Disassembly

2C-6 Rear Suspension:
6) Remove the rear shock absorber lower mounting
bolt and nut.
7) Remove the rear shock absorber.
Installation
Install the rear shock absorber in the reverse order of
removal. Pay attention in the following points:
• Tighten the rear shock absorber lower mounting nut
(1) to the specified torque.
Tightening torque
Rear shock absorber lower mounting nut (a): 50
N·m (5.0 kgf-m, 36.0 lbf-ft)
• Tighten the rear shock absorber upper mounting nut
(2) to the specified torque.
Tightening torque
Rear shock absorber upper mounting nut (b): 50
N·m (5.0 kgf-m, 36.0 lbf-ft)
• Pass the wiring harness and clamp them securely.
Refer to “Wiring Harness Routing Diagram” in Section
9A (Page 9A-2).
Rear Shock Absorber Disassembly
BA02J22306006
Bearing
1) Remove the spacers (1).
2) Remove the dust seals (2).
3) Remove the needle rollers (26 pcs) (3).
IA02J1230006-01
(a)
1
IA02J1230007-01
(b)
2
IA02J1230008-01
1
IA02J1230010-01
2
IA02J1230011-01
3
IA02J1230012-01