9A-2 Wiring Systems:
Wiring Harness Routing Diagram
BA02J29102002
1
4
5
6
8
2
3
7
“A”
IA02J1910909-02
1. Clamp
: Bind the engine stop switch lead wire. Set the tip of clamp foreword.
6. Steel clamp
: Fix the steel clamp toward the front side. Clamp the fuse box
lead wire, ignition switch lead wire, speedometer lead wire and
speed sensor lead wire.
2. Clamp
: Bind the engine stop switch lead wire and clutch position switch lead wire. Set
the tip of clamp foreword.
7. Clamp
: Bind the fuse box lead wire and ignition switch lead wire. Set
the lock part of clamp to the right side and tip of clamp
backward.
3. Clamp
: Bind the starter button lead wire. Set the tip of clamp foreword.
8. Starter button lead wire
: Pass the starter button lead wire behind the cables.
4. Clamp
: Bind the wiring harness to the combination bracket. Set the lock part of clamp
downward and tip of clamp to the right side.
“A”: Pass the wiring harness inside the left harness guide.
5. Steel clamp
: Fix the steel clamp to 45° in the right-back side. Clamp the clutch position
switch lead wire, speedometer lead wire and gray taping point of the wiring
harness.
To Next Page
Loading...
