Suzuki RMX450Z - Recommended Service Material; Service Data; Special Tools and Equipment; Specifications

5C-13 Clutch:
Specifications
Service Data
BA02J25307001
Clutch
Unit: mm (in)
Tightening Torque Specifications
BA02J25307002
NOTE
The specified tightening torque is described in the following.
“Clutch Control System Components” (Page 5C-3)
“Clutch Components” (Page 5C-6)
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List” in Section 0C
(Page 0C-8).
Special Tools and Equipment
Recommended Service Material
BA02J25308001
NOTE
Required service material is also described in the following.
“Clutch Control System Components” (Page 5C-3)
“Clutch Components” (Page 5C-6)
Item Standard Limit
Clutch lever clearance 2.0 – 3.0 (0.08 – 0.12) —
Drive plate thickness (No. 1 & No. 2) 3.07 – 3.23 (0.121 – 0.127) 2.77 (0.109)
Drive plate claw width
(No. 1 & No. 2)
13.85 – 13.95 (0.545 – 0.549) 13.05 (0.514)
Driven plate distortion — 0.10 (0.004)
Clutch spring free length 51.94 (2.045) 49.4 (1.945)
Fastening part
Tightening torque
Note
N⋅mkgf-mlbf-ft
Clutch sleeve hub nut 90 9.0 65.0 )(Page 5C-9)
Clutch spring set bolt 10 1.0 7.0 )(Page 5C-10)
Clutch cover bolt 11 1.1 8.0 )(Page 5C-11)
Material SUZUKI recommended product or Specification Note
Grease SUZUKI SUPER GREASE “A” or
equivalent
P/No.: 99000–25010 )(Page 5C-4)
Moly paste SUZUKI MOLY PASTE or equivalent P/No.: 99000–25140 )(Page 5C-4)