Introduction
123Scan² is an easy-to-use, PC-based software tool that enables the quick and easy setup of Zebra scanners.
123Scan² uses a wizard tool to guide users through a streamlined set up process. Once parameters are set, the values are saved
to a configuration file that can be distributed via e-mail, electronically downloaded via a USB or RS-232 cable, or used to generate
a sheet of programming bar codes that can be scanned.
123Scan² can generate multiple reports that can be easily rebranded using Microsoft Word or Access. Report options include
programmed parameters, asset tracking information and proof of scanner output.
Additionally, 123Scan² can display scanned bar code data including non-printable characters. It can display, optimize and save
pictures from an imaging scanner. It can also upgrade scanner firmware, automatically check online to enable support for newly
released products, generate a single 2D bar code for one scan programming and stage large numbers of scanners simultaneously
via USB hub(s).
Communication with 123Scan2
To communicate with the 123Scan² program which runs on a host computer running a Windows XP SP2 and Windows 7 operating
system, use a USB cable to connect the scanner cradle to the host computer (see Connecting a USB Interface on page 7-1).
123Scan2 Requirements
• Host computer with Windows XP SP2 or Windows 7
• Scanner
• Cradle (cordless scanning only)
• USB cable.
For more information on 123Scan², go to:
http://www.zebra.com/123Scan
For a one minute tour of 123Scan², go to:
www.zebra.com/scannersoftwarevideos.
To download 123Scan² software and access the Help file integrated in the utility, go to:
http://www.zebra.com/support
Chapter 12123Scan2
To Next Page
Loading...
