6 - 4 LS7708 Scanner Product Reference Guide
RS-232 Default Parameters
Table 6-8 lists the defaults for RS-232 host parameters. To change any option, scan the appropriate bar code(s) beginning in RS-
232 Host Parameters on page 6-5.
Scanning parameter setting bar codes with the primary scanner also changes settings on the auxiliary
scanner.
See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 6-8 RS-232 Host Defa ult Table
Parameter Default Page Number
RS-232 Host Parameters
RS-232 Host Types Standard
1
6-9
Baud Rate 9600 6-13
Parity None 6-17
Check Receive Errors Enable 6-20
Hardware Handshaking None 6-21
Software Handshaking None 6-24
Host Serial Response Time-out 2 Sec 6-26
RTS Line State Low RTS 6-29
Stop Bit Select 1 6-30
Data Bits 8-Bit 6-31
Beep on <BEL> Disable 6-32
Intercharacter Delay 0 msec 6-33
Nixdorf Beep/LED Option Normal Operation 6-35
Ignore Unknown Characters Send Bar Codes 6-37
1
User selection is required to configure this interface and this is the most common selection.
Note
Note
To Next Page
Loading...
