Symbol LS7708 - Appendix A Standard Default Parameters; User Preferences; Keyboard Wedge Host Parameters

Table A-1 Standard Default Parameters Table
Parameter Default Page Number
User Preferences
Set Default Parameter All Defaults 4-3
Beeper Tone Medium 4-3
Beeper Volume High 4-5
Beep After Good Decode Enable 4-7
Low Power Mode Low Power Blink Mode 4-8
Scan Pattern Mode Rastering 4-9
EAS Interlock Disable 4-15
Time-out Between Same Symbol 0.6 sec 4-10
Time-out Between Different Symbols 0.2 sec 4-10
Time Delay to Low Power Mode 30 Minutes 4-11
Linear UPC/EAN Decode Disable 4-13
UPC Half Block Stitching Enable 4-14
EAS Interlock Disable 4-15
Keyboard Wedge Host Parameters
Keyboard Wedge Host Type IBM PC/AT& IBM PC
Compatibles
1
5-5
1
User selection is required to configure this interface and this is the most common selection.
Appendix AStandard Default Parameters