Symbol LS7708 - Errors While Scanning; User Preferences Default Parameters

4 - 2 LS7708 Scanner Product Reference Guide
Errors While Scanning
Unless otherwise specified, if an error occurs during a scanning sequence, just re-scan the correct parameter.
User Preferences Default Parameters
Table 4-6 lists the defaults for user preferences parameters. To change any option, scan the appropriate bar code(s) beginning in
User Preferences on page 4-3.
See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 4-6 User Preferences Default Table
Parameter Default Page Number
User Preferences
Set Default Parameter All Defaults 4-3
Beeper Tone Medium 4-3
Beeper Volume High 4-5
Beep After Good Decode Enable 4-7
Low Power Mode Low Power Blink Mode 4-8
Scan Pattern Mode Rastering 4-9
Time-out Between Same Symbol 0.6 sec 4-10
Time-out Between Different Symbols 0.2 sec 4-10
Time Delay to Low Power Mode 30 Minutes 4-11
Linear UPC/EAN Decode Disable 4-13
UPC Half Block Stitching Enable 4-14
EAS Interlock Disable 4-15
Note