Introduction
This chapter includes bar codes used to customize how data is transmitted to the host device. Also see each host chapter for the
appropriate host connections and host device features for the scanner. Before programming, follow the instructions in Chapter
1, Getting Started.
The scanner is shipped with the settings shown in the Table 14-22 (also see Appendix A, Standard Default Parameters for all
host device and miscellaneous scanner defaults). If the default values are suitable, programming is not necessary. Set feature
values by scanning single bar codes or short bar code sequences.
Throughout the programming bar code menus, asterisks (
*) indicate default values.
Scanning Sequence Examples
In most cases, scan only one bar code to set a specific parameter value. Other parameters, such as Prefix Value, require
scanning several bar codes in sequence. See individual parameters for descriptions of this procedure.
Errors While Scanning
Unless otherwise specified, if an error occurs during a scanning sequence, just re-scan the correct parameter.
Miscellaneous Default Parameters
Table 14-22 lists the defaults for miscellaneous scanner options parameters. To change any option, scan the appropriate bar
code(s) beginning in Miscellaneous Scanner Parameters on page 14-3.
Scanning parameter setting bar codes with the primary scanner also changes settings on the auxiliary scanner.
See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 14-22 Miscellaneous Scanner Options Default Table
Parameter Default Page Number
Transmit Code ID Character Disable 14-3
Note
Note
Chapter 14Miscellaneous Scanner
To Next Page
Loading...
