Symbologies 13 - 19
Supplemental User-Programmable 2
UPC/EAN Supplemental Redundancy
With Autodiscriminate UPC/EAN Supplementals or one of the supplemental modes selected, this option adjusts the number
of times a symbol without supplementals is decoded before transmission. The range is from two to thirty times. Five or above is
recommended when decoding a mix of UPC/EAN symbols with and without supplementals, and the autodiscriminate option is
selected. The default is set at 20.
Scan the bar code below to set a decode redundancy value. Next, scan two numeric bar codes beginning on page D-1 in Appendix
D, Numeric Bar Codes. Single digit numbers must have a leading zero. If an error occurs, or to change the selection, scan Cancel
on page D-6.
UPC/EAN Supplemental Redundancy
To Next Page
Loading...
