13 - 50 LS7708 Scanner Product Reference Guide
Transmit Buffer
There are two methods to transmit the Code 39 buffer.
1.Scan the Transmit Buffer bar code below. Only a start character, a plus (+), and a stop character.
• The scanner transmits and clears the buffer.
• The scanner issues a lo/hi beep.
Transmit Buffer
2.Scan a Code 39 bar code with a leading character other than a space.
• The scanner issues a hi/lo beep to indicate a good decode and that buffering of the decode data has occurred.
• The scanner transmits and clears the buffer.
• The scanner signals that the buffer was transmitted with a lo/hi beep.
The Transmit Buffer contains only a plus (+) character. In order to scan this command, be sure Code 39
length is set to include length 1.
Note
To Next Page
Loading...
