Standard Default Parameters A - 3
USB Host Parameters
USB Device Type HID (Human Interface Device)
Keyboard Emulation
7-5
USB Country Keyboard Types (Country Codes) North American 7-7
USB Keystroke Delay No Delay 7-12
USB CAPS Lock Override Disable 7-14
USB Ignore Unknown Characters Send Bar Codes 7-15
Emulate Keypad Disable 7-16
USB Keyboard FN1 Substitution Disable 7-17
Function Key Mapping Disable 7-18
Simulated Caps Lock Disable 7-19
Convert Case Disable 7-20
IBM 468X/469X Host Parameters
Port Address None Selected
1
8-4
Convert Unknown Bar Code 39 Disable 8-6
RS-232 Auxiliary Port Parameters
Baud Rate 9600 10-4
Parity None 10-7
Check Receive Errors Enable 10-9
Hardware Handshaking None 10-10
Software Handshaking None 10-19
Serial Response Time-out 2 sec 10-15
RTS Line State Low RTS 10-18
Stop Bit Select 1 10-19
Data Bits 8-Bit 10-20
Hand-Held Laser Scanner Parameters
Programming Mode Program Primary Scanner
Only
11-3
Beep After Good Decode Disable 11-5
Table A-1 Standard Default Parameters Table (Continued)
Parameter Default Page Number
1
User selection is required to configure this interface and this is the most common selection.