1
TimeSource 3100 129
TL1 Reference
097-72020-01 Issue 9: November 2003
2
5
3
SSSSSSSSSSSS SSSS S SSSSS SSSS SSS S SSS S SSSSS
44
Edit Communication (cont’d)
The parameters which can be entered in the <spec_block> are listed below. For any specific
<aid> entered in a command, only certain parameters are valid. For each valid parameter,
choose the appropriate value from the Value column. When entering multiple parameters,
separate the parameters with commas.
Aid Parameter Value Description
COM-a MONMSG=b b = ALW View messages from all ports
b = INH View messages from this port only
KEEPALIVE = b b = 1 to
255
Inactive minutes until the unit sends a
COMPLD message to keep the connection
from being closed
b = 0 No COMPLD message is output
ENDOFTEXT = b b = 1 to
9F
Hex code at end of all responses
b = 0 No hex code at end of responses
ECHO = b b = ALW Echoes characters received so they appear
on the user’s screen as typed
b = INH Local echo is disabled
COMPRI = b b = ALW0 TL1 commands and responses, no
autonomous messages sent
b = ALW1 TL1 commands and responses, autonomous
messages
b = ALW2 TL1 commands and responses, autonomous
messages whether logged on or not
b = INH Closes connection, logs off any user (if
logged on), and keeps port from use.
Releases a telnet session from an Ethernet
port (a port cannot close itself).
AUTOLOGOFF = b b = 1 to
255
Inactive minutes until the unit logs off the
user, keeping the connection open
b = 0 Autologoff is disabled
HWCONTROL = b
(See Note 2)
b = ALW Serial port CTS/RTS flow control is enabled
b = INH Serial port CTS/RTS flow control is not
enabled
SWCONTROL = b
(See Note 2)
b = ALW XON/XOFF flow control is enabled
b = INH XON/XOFF flow control is not enabled
To Next Page
Loading...
Need help?
General
