82 Preparation for Operation TB7100 Installation and Operation Manual
© Tait Electronics Limited December 2005
7.3.5 Programming
To program a base station for line-controlled base operation follow the
instructions below. Do not add CTCSS or any additional settings at this
stage. These are covered in “Programmable Features” on page 105. See
“Connecting to the PC” on page 105 before beginning.
Transmitter 1. Place the transmit/receive programming switch on the user interface
into the transmit position.
2. Read the transmitter or start with a new transmitter data file.
3. Use the reset to defaults command under the file menu to ensure all
the mandatory and recommended settings are in their correct default
states.
4. Open the specifications form and select the correct RF band, not
required if the transmitter file was read.
5. Open the channels form and add as many channels as are required.
For each channel enter the:
■ transmit frequency
■ Tx subaudible signalling value (leave as “None”)
■ power level
■ bandwidth.
6. Open the key settings form and select the required function for each
function key.
For example:
■ FN1 = Preset Channel
■ FN2 = Preset Channel
■ FN3 = Preset Channel
■ FN4 = None
7. Program the transmitter.
Receiver 1. Place the transmit/receive programming switch on the user interface
into the receive position.
2. Read the receiver or start with a new receiver data file.
3. Use the reset to defaults command under the file menu to ensure all
the mandatory and recommended settings are in their correct default
states.
4. Open the specifications form and select the correct RF band, not
required if the receiver file was read.
5. Open the channels form and add as many channels as are required.
For each channel enter:
To Next Page
Loading...
Need help?
General
