4-167
4
SLEW MOTOR
DISASSEMBLY AND ASSEMBLY
7. Take out the cap screws, and then remove the thrust
place (14) from the carrier 2 (13).
• Secure the carrier 2 in a vise.
• The cap screws are locked with Loctite. Warm up
the screws for easy removal (using a portable dryer,
for example).
8. Remove the planetary gear (15), needle (16), inner race
(17) and thrust washer (18) from carrier 2 (13).
9. Remove the collar (9) and plate (10).
10. Remove the shaft (11).
• Take care that the shaft does not drop out.
• If it is difficult to remove, tap it lightly with plastic
hammer.
• If the housing, taper roller bearing, plate, shaft or
collar requires replacement, replace the entire hous-
ing assembly.
To Next Page
Loading...
