Talsa K80v - Technical Specifications; Storage, Transport & Delivery

K80v / K120v BOWL CUTTERS
MANUAL
EN-20
3.
TECHNICAL SPECIFICATIONS
K80v
K120v
Bowl capacity
80 liters
120 liters
Approximate meat capacity of bowl
± 15 to 60 kg
± 20 to 90 kg
Total machine power
24.5 kW (34 HP)
32.5 kW (44 HP)
Knife-motor power
380 / 400 volts
22 kW
30 kW
208 / 230 volts
Bowl-motor power
1.5 / 2.5 kW (2 / 3.4 HP)
Optional unloading disk-motor power
0.55 kW (0.75 HP)
Total consumption
380 / 400 volts
44 Amp
59 Amp
460 / 480 volts
39 Amp
52 Amp
208 / 220 / 230 volts
78 Amp
100 Amp
Rotational knife speed
1,000 to 4,000 rpm
Linear knife speed, 50 Hz / 60 Hz machines
1000 rpm
22 m/sec.
25 m/sec.
2000 rpm
44 m/sec.
50 m/sec.
3000 rpm
66 m/sec.
75 m/sec.
4000 rpm
87 m/sec.
100 m/sec.
Rotational bowl speed
50 Hz
9 or 18 rpm
60 Hz
11 or 21 rpm
Rotational knife speed in standard mixing
100 rpm forward and reverse
Rotational speed of optional motorized
unloading disc
50 Hz
130 rpm
60 Hz
155 rpm
Machine dimensions (width x depth x height)
154x118x128 cm
174x134x133 cm
Packaging dimensions (width x depth x height)
164x134x155 cm
196x154x158 cm
Approximate net weight
1,087 kg
1,500 kg
Maximum noise level in dB(A) LEQ at 1 m
Up to 75 dB
Environmental functioning temperature
+5 to +40ºC
Acceptable level of environmental relative humidity
20 to 90 %
4.
STORAGE, TRANSPORT AND DELIVERY
The machine is delivered in a protective wooden crate. We ask that you please recycle
the packing materials. Since the machines and crating are bulky, make sure there is
enough free space available for proper storage and/or transport, especially if storing
or shipping more than one unit.
Uncrate and carefully inspect the machine upon delivery. Should you note any damage
to the machine, retain all packing materials and promptly notify the carrier. The
transport company is solely responsible for any damage to the machine during transit.
If the machine is found to be in satisfactory condition, convey it to a suitable work area
with a flat, level floor. Because of its weight (see the above Technical Specifications
table), the machine must always be moved with a pallet mover or forklift. Use care
when sliding the forklift’s blades underneath the machine.
The following items are enclosed in the crate with the Talsa cutter:
 6-knife cutting head (already installed).
 2 wrenches for assembling and dismantling the knives (one double-ended and
one single-ended).
 4 supplementary rings to allow use of the machine with just 3 knives.
 Instruction manual.
 CE-conformity for units sent to countries within the EU or belonging to the CEN.
Warning!
 ALWAYS keep the machine upright,
even while it is still crated.
 NEVER stack machines. DO NOT rest
heavy objects on the machine or its
crate.
 NEVER lift the cutter by the cutting
head shaft support since this could
result in serious damage to both the
support and the shaft.