(4) Chain blocks
· Do not toss or drag a chain block. If a block becomes wet, wipe
away the moisture and lubricate it properly. An elongated or
deformed hook should not be used.
· Make sure that the hook and other lifting equipment is working
properly before use.
· Do not use a chain block with any cracks or deformation in the
welds or shoulders.
<Installing and removing forks>
(1) With the forks raised a little off the ground, place blocks under the
root of the forks. Bring both fork prongs to the center by alternately
pushing on the top and bottom (heel) of the fork face. Do not use
your hands. Otherwise you might get your hands or ngers pinched.
(2) Put blocks under the root of the forks. Lower the forks to disengage
the forks from the carriage.
(3) Lift the tip of each fork prong to remove it from the carriage.
Do not
toss!
Do not
drag!
Welded
part
Shoulder
Check visually for deformation and
replace as necessary.
No good No good No good
To Next Page
Loading...
