What causes poor load regulation on TDK-Lambda Z+ series Power Supply when front panel CV LED is on?
If you're experiencing poor load regulation on your TDK-Lambda Power Supply while the front panel CV LED is on, the sensing wires might not be connected properly. Connect the sense wires according to User's Manual instructions.
Details the product warranty period, limitations, and service procedures.
Essential safety precautions for operation, service, and repair.
Emphasizes proper grounding and safety for live circuits.
Warns about AC input requirements and hazardous energy levels.
Detailed specifications for the Z+ 200 Series power supplies.
Detailed specifications for the Z+ 400 Series power supplies.
Guides on initial inspection, preparation, and rack mounting.
Details AC source requirements, connection, and checkout procedures.
Guides on connecting the load and using local/remote sensing.
Explains front panel controls, displays, messages, and menu navigation.
Describes Constant Voltage/Current modes, auto-crossover, and output control.
Covers OVP, UVP, Foldback, Interlock, AC Fail, and OTP alarms.
Explains connecting units in series, parallel, and daisy-chain configurations.
Explains the functions of J1 and J3 rear panel connectors.
Covers memory functions for saving and recalling settings.
General| Remote Sense | Yes |
|---|---|
| Input Voltage Range | 85-265VAC |
| Cooling | Forced air |
| Operating Temperature | -10°C to +70°C (derating may apply above +50°C) |
| Safety Standards | UL/IEC/EN 60950-1 |
| Programming | Analog |
| Digital Interface | RS-232, RS-485, USB |
| Protections | OVP, OCP, OTP |
To Next Page