If the wet-leg sensor shows as 'wet' due to the medium passing through from
the compartment, the current discharge process can be started at any time by
connecting the discharge hose and pressing the compartment number as long
as no delivery note has been printed!
The process described is then repeated.
7
Ending the discharge process – Measurement / end
Operation:
Discharge all the other compartments
using the same process as for
compartment 1.
Once all the compartments have been
discharged and all hoses and GWG
cables removed, create a printout.
To do this, the compartment
measurement must have ended,
which is indicated by the letter 'E'
above the compartment number.
8
Print delivery note
Operation:
Insert paper into the printer and press
the <Print> key on the MultiLevel control
panel.
You will now be asked to select a
form layout <F1> / <F2>. For example,
the discharge volumes of a product
can be used to create a combined
volume.
Start the print process by pressing the
<Print> key again.
IMPORTANT:
No delivery note is printed for compartments without a valid measurement,
indicated by an 'M' above the compartment number. The print process can be
'E' above the
compartment number.
☺
The discharge process is now complete.
MultiLevel Instruction Manual Quick Start
To Next Page
Loading...
Need help?
General
