3132142 – Max. Pitch
Setting for the maximum pitch. If this value is exceeded, the delivery is
uncalibrated when the wet leg sensor runs dry.
Example: +3°
(Vehicle higher at the front ==> setting is normally suitable for a front compart-
ment!)
Figure 46: Tank truck inclined positively in a longitudinal direction by +3°
value in ° (degrees)
3132143 – Min. Roll
Setting for the minimum roll. If this value
is undershot, the delivery is uncalibrated
when the wet leg sensor runs dry.
Example: -3,0°
Value in ° (degrees)
Figure 47: Tank truck inclined negatively in a transverse direction by -3,0°
3132144 – Max. Roll
Setting for the maximum roll. If this value
is exceeded, the delivery is uncalibrated
when the wet leg sensor runs dry.
Example: +3°
Value in ° (degrees)
Figure 48: Tank truck inclined positively in a transverse direction by +3,0°
3132145 – Min. Delivery Quantity
Entry of the minimum delivery quantity permissible in terms of calibration. The
litres
3132146 – Max. Change in Volume
Input of the maximum change in volume of a ‘non-active’ compartment that is
tolerated during delivery from one or more other compartments. If the value
should be exceeded, the system interprets this as manipulation and an extend-
ed receipt is printed with the height measurements before and after the delivery
of all compartments. All measurements are marked as uncalibrated.
litres
MultiLevel Instruction Manual MENU structure
To Next Page
Loading...
Need help?
General
