Technogym RUN 1000 - Custom Maximal Test

26
Run 1000 - Advanced LED display
The maximal tests
Custom maximal test
The custom maximal test is for very t users in good state of health.
To perform this test, in addition to age, weight and gender, you must also set the workloads.

Type in the test starting speed with the number keys, then press ENTER to conrm and proceed.
The minimum value is 7.0 km/h, because the test is in run mode.

Type in how much the load must increase between one step and the next with the number keys; then press ENTER to conrm and proceed.

Type in the time, in minutes and seconds, for each step with the number keys; then press ENTER to conrm and proceed.
There is no specic warm up stage; therefore you are advised to set the rst step or steps with appropriate loads or to warm up for a few minutes before the test.
The test ends when the user is exhausted and presses the STOP key.