Technogym RUN 1000 - Programming Personal Profiles

59
Run 1000 - Advanced LED display
Programming personal proles
To program personal proles, when in standby press number keys 3 6 9 simultaneously; then enter the password 2412 with the number keys and conrm with
ENTER.
9
Type in the number of the prole to be saved with the number keys, then press ENTER to conrm. If the number entered corresponds to a previously stored
prole, this prole will shown in the led display; if you proceed at this point, the previously stored prole will be overwritten.

Press number key 1 to program a constant power prole, i.e. with constant speed and gradient values; otherwise, press number key 2 to program a constant
heart rate prole.

Press the key for the selected GOAL.
For the CPR prole you must select the execution mode:

Press number key 1 to select a slow speed, which will be the walk mode when carrying out the exercise; otherwise, press number key 2 to select a faster speed
and therefore the run mode.