Technogym RUN 1000 - Single Stage Model

39
Run 1000 - Advanced LED display
The submaximal tests
Single stage model
This is a submaximal protocol, in which the load is set by the user:

Type in the treadmill speed, in kilometres per hour, with the number keys and then press ENTER to conrm and proceed.

Type in the treadmill gradient for the rst step in percentage with the number keys and then press ENTER to conrm and proceed.
The single stage model includes a 90 second warm up, at half the set speed and gradient of 0%; followed by a 5 minute eort stage.
During the cool down the results are scrolled on the alphanumeric display:

4
4


When the STOP key is pressed, or if there is no heart rate signal for 100 consecutive seconds the test is cancelled, then it ends without giving any result.