Technogym RUN 1000 - Page 68

68
Run 1000 - Advanced LED display
Conguration menu

To enable the equipment to be used with the TGS key. If the TGS is disabled, the equipment can be used only with the control panel.

To enable the equipment with the function keys. If the function keys are disabled, the equipment can be used only with the TGS key.

To enable or disable the treadmill gradient.

If the language is xed, all the messages will be in the language set in the current conguration menu; if the language is optional, it can be changed when in
standby.

Resets all the initial settings that were on the equipment when it was rst purchased.

To set the speed (in the example 5.0 km/h) at which the “user present” function activates. To deactivate the function, enter a value of between 0 and 3.
If the function is active, at the set speed a check is made to determine whether there is a user in the treadmill; if no user is detected within one minute, the
equipment stops and the exercise ends. The function does not activate, however, if the weight of the user entered during the exercise setting phase is less than
50 kg.