STEP 600 XTPRO: Service & Maintenance Manual - rev. 1.1
Page 6.2
6.1. THE DISPLAY DOES NOT ILLUMINATE
This error is generated when the supply voltage does not reach the control panel.
Does the wall output supply
the correct voltage?
Is the mains lead OK?
VAre the fuses OK?
Connect machine to a
suitable
electrical output
Replace the mains lead
Replace the blown
fuses
Replace the input
socket / on-off switch
block of the machine
THE DISPLAY
DOES NOT
ILLUMINATE
Is the mains voltage present at
the output of the power input
socket
NO
YES
NO
YES
NO
YES
NO
YES
1
A
Continued on the following page.
To Next Page
Loading...
