STEP 600 XTPRO: Service & Maintenance Manual - rev. 1.1
Page 10.2
10.2. ROUTINE MAINTENANCE OPERATIONS
These operations can be carried out by the owner of the machine and do not require any
special skills.
The routine maintenance operations involve simple cleaning, lubrication and checking the state of
wear, in order to ensure the correct and safe operation of the machine. It is recommended to perform
these operations at least once a month.
For the routine maintenance of the machine, proceed as follows:
10.2.1. SETTING UP THE OPERATION
1. Turn off the machine by placing the switch in the 0 position (OFF).
2. Unplug the mains lead from the wall outlet.
3. Open the machine guards.
10.2.2. INTERNAL CLEANING
1. Use a vacuum cleaner to clean the interior, paying particular attention to the alternator and the
electronic circuit boards.
WARNING: when carrying out these operations, be careful not to damage the cables.
2. Move the machine and clean the floor underneath using a vacuum cleaner.
10.2.3. LUBRICATION
1. Lubricate the pedal chains with chain spray grease that comes with the service box.
2. After lubricating them, move the pedals up and down a few times.
10.2.4. CHECKING THE STATE OF WEAR OF THE PEDAL CHAINS
1. Check the state wear of the pedal chains, inspecting their entire length and in particular the
coupling with the primary shaft sprocket wheels. If any anomalies are found (links that are
jammed and/or have excessive play), call in the authorized Technogym Technical Service.
10.2.5. CHECKING THE AMOUNT OF PLAY ON THE BALL JOINTS
1. Check the amount of play on the ball joints, taking a pedal in one hand and moving it. If any
anomalies are found, call in the authorized Technogym Technical Service or adjust the amount
of play.
To Next Page
Loading...
