Technogym Step 600 XTPRO - Disassembling the Alternator Brushes

STEP 600 XTPRO: Service & Maintenance Manual - rev. 1.1
Page 7.29
7.25. DISASSEMBLING THE ALTERNATOR BRUSHES
Figure 7.25-1
Carry out the procedure described in paragraph
7.8. “Disassembling the frame guard”.
1. Disconnect cable a from the alternator.
2. Back off the BRUSH group clamping screw
b using a medium Phillips screwdriver.
3. Remove the BRUSHES.
To reassemble the BRUSHES, carry out the
above steps in reverse order.