STEP 600 XTPRO: Service & Maintenance Manual - rev. 1.1
Page 7.24
Figure 7.21-3
4. Working from both sides of the machine,
back off the counternut d and lock down the
adjusting screw e of the SECONDARY
SHAFT using a 13-mm wrench.
5. Unscrew the 4 screws f fixing the
SECONDARY SHAFT to the frame using a
17-mm wrench.
6. Remove the SECONDARY SHAFT,
removing the belt g.
To reassemble the SECONDARY SHAFT, carry
out the above steps in reverse order.
After completing the procedure, adjust
the alignment and tension of the belt and
of the primary shaft - secondary shaft
chain as described in paragraphs 8.1. ,
8.2. , 8.3. and 8.4. .
To Next Page
Loading...
