UNICA EVOLUTION: Service & Maintenance Manual - rev. 1.1
8.3. SPECIAL MAINTENANCE
These operations must be carried out only by a qualified technician specially trained by
Technogym and authorized to perform machine settings and start-up as well as special
maintenance or repairs requiring in-depth knowledge of the machine, its operation, its
safety features and intervention procedures.
Special machine maintenance operations include operative checks, lubrication, wear and tension of
mechanical parts, to ensure smooth, safe machine operation. We recommend that you carry out
these operations at least once every 6 months.
Follow the procedure below for special machine maintenance:
8.3.1. REPLACING THE CABLES
1. Replace the machine cables once a year if the machines are used intensively, every 2 years
under normal use.
8.3.2. SCREW AND BOLT CHECK
1. Make sure that the screws and bolts are firmly tightened, especially in the weight stack and seat
adjustment areas, and around moving parts in general. Tighten any that are loose.
8.3.3. CHECKING FOR MECHANISM PLAY
1. Make sure that the machine mechanisms (lever arms, shafts, starting position adjustments,
leverages) have no play. Repair and/or replace any worn parts.
8.3.4. CHECKING CROSS ALIGNMENT
1. Do not select any weight, and lift the cross. Make sure that the sinker is properly centered over
the plate hole, and that all plates in the weight stack may be selected without any strain on the
selection knob. Force it to the center by hand.
Page 8.5
To Next Page
Loading...
