UNICA EVOLUTION: Service & Maintenance Manual - rev. 1.1
Page 10.8
10.1.18. CLOCK SETTING: HOURS
This item sets the hours of the internal clock. The display shows:
MACHINE CONFIGURATION
SET CURRENT TIME
HOURS
12
Enter the value then press OK to confirm and proceed.
10.1.19. CLOCK SETTING: MINUTES
This item sets the minutes of the internal clock. The display shows:
MACHINE CONFIGURATION
SET CURRENT TIME
MIN.
30
Enter the value then press OK to confirm and proceed.
10.1.20. INACTIVE TIME BEFORE END OF SET
This item configures how many seconds must elapse, after the weight stack has returned to the
weight position, before the software considers the set finished. The display shows:
MACHINE CONFIGURATION
TIME OUT WEIGHT STACK
SECS
4
Enter the value and press OK to confirm and proceed.
At this point the configuration of the Wellness Mate parameters is complete; after sounding a beep,
the software reverts to stand by mode.
To Next Page
Loading...
