UNICA EVOLUTION: Service & Maintenance Manual - rev. 1.1
Page 10.12
CONFIGURATION
ROM FIRST REP
XX PERCENT
Insert number 45.
10.3.6. TYPE OF ENCODER USED
This item configures the type of encoder used on the machine. The display shows:
CONFIGURATION
ENCODER TYPE
0=INFRA 1=WIRE 2=WIRE M
1
The possible settings are:
• 0 for an infrared system;
• 1 for the cable activated encoder that is currently installed;
• 2 for a different model of cable activated encoder.
Leave this setting at 1, then press OK to confirm and proceed.
10.3.7. ENABLE DISPLAY ADJUSTMENTS
This item selects whether to display the icon for adjusting the LCD contrast and brightness, as
described in paragraph Errore. L'origine riferimento non è stata trovata. “Errore. L'origine
riferimento non è stata trovata.”, when the machine is in stand by mode. The display shows:
CONFIGURATION
ENABLE DISPLAY SETTINGS
0 = NO 1 = YES
1
The possible settings are:
• 1 to enable the display of the icon;
• 0 to disable it.
Select the desired value then press OK to confirm and proceed.
To Next Page
Loading...
