UNICA EVOLUTION: Service & Maintenance Manual - rev. 1.1
- AW: shows whether the additional weight has been selected: Y if it is in the rest
position and N if it is raised. In other words, this parameter monitors the state of
the additional weight sensor;
ATTENTION: to see the change of sensor state on the display, it is necessary to raise
the weight stack.
ATTENTION: the refresh rate for these parameters is very slow – in the order of a
few seconds: therefore, to see a change in the displayed values after modifying the
machine status, it is necessary to hold the position and wait.
To exit this view, press the OK key: after sounding a beep, the software will return to stand by
mode.
Page 10.19
To Next Page
Loading...
