Tektronix CSA7404B - Page 255

Removal and Installation Procedures
CSA7404B, TDS7704B, TDS7404B, TDS7254B & TDS7154B Service Manual
6-35
5. Remove the hard disk drive from the cartridge: See Figure 6--20, on
page 6--35.
a. Separate the two halves of the drive cartridge. C arefully pry the detents
on the cartridge cover above the slot in the bottom of the cartridge (insert
the blade of a small flat-bladed screwdriver and twist). Remove the top
of the cartridge.
b. Remove the four #0 Phillips screws that fasten the hard-disk drive to the
drive assembly.
c. Carefully remove the hard disk drive from the cartridge by pulling
forward on the drive, removing the drive from the socket.
Remove 4
screws
Hard drive cartridge
back side
Hard disk
drive
Hard drive cartridge
Figure 6- 20: Hard disk drive removal from cartridge