Removal and Installation Procedures
6-36
CSA7404B, TDS7704B, TDS7404B, TDS7254B & TDS7154B Service Manual
1. Locate module to be removed: Locate the CD Drive in the locator diagram
Internal Modules, Figure 6--8, on page 6--21. Additional modules to be
Removed:
H Trim (all)
H Bottom cover
H Left and Right covers
2. Remove the CD Drive assembly: See Figure 6--21, on page 6--36.
3. Orient the instrument: Set the instrument so its bottom is down on the work
surface and its rear panel is facing you.
a. Remove the two T-15 Torxdrive screws that secure the CD Drive
assembly to the rear chassis.
b. Pull the drive until the connector disconnects.
c. Slide the CD Drive assembly away from the rear of the chassis and
remove it from the instrument.
CD drive
assembly
T-15 Torxdrive
screw (2)
Figure 6- 21: CD drive assembly removal
CD Drive
To Next Page
Loading...
