Tektronix TG8000

GPS7 GPS Synchronization and Timecode module remote commands
:OUTPut4:LTC[
1/2/3/4]:SOURce?
Returns the current linear timecode source setting.
:OUTPut4:LTC[1/2/3/4]:OFF Set <NR1>,<NR1>,<NR1>,<NR1>
Sets the linear timecode offset in hours, m inutes, seconds, a nd frames
(HH:MM:SS:FF).
:OUTPut4:LTC[1/2/3/4]:OFF Set?
Returns the linear timecode offset in hours, minutes, seconds, and frames
(HH:MM:SS:FF).
:OUTPut4:LTC[1/2/3/4]:TYP E N23_FPS|N24_FPS|N25_FPS|N30_FPS|
D30_FPS
Sets the linear timecode type.
:OUTPut4:LTC[1/2/3/4]:TYP E
Return
s the type of linear timecode output.
:OUTPut4:LTC[1/2/3/4]:LEV el <numeric_value>
Sets the voltage level of the linear timecode signal. The value specified must
be in floating point format. The range is from 0.5 to 5.0 volts, in 0.5 volt
incre
ments.
:OUTPut4:LTC[1/2/3/4]:LEV el?
Returns the voltage level of the linear timecode signal.
:OUTPut4:LTC[1/2/3/4]:MDE Lay <Numeric_value>
Sets the delay for the linear timecode. The value specified must be in fl oating
point format. Units are milliseconds.
:OUTPut4:LTC[1/2/3/4]:MDE Lay
Returns the delay setting for the linear timecode. Units are milliseconds.
:
OUTPut4:LTC[1]:STATE 0 | 1
1 - set LTC(1) as input. 0 - set LTC(1) as output (if allowed); meaning that
LTC1 is an output, if LTC is not selected as a TOD source. (Only valid for
LTC(1) and when GPS7 module has an RF IN connector.)
Draft
94 TG8000 Multiformat Test Signal Generator Programmer Manual