Tektronix TG8000

HD3G7 3 Gb/s SDI Video Generator module remote commands
:OUTPut1:VIDe
o:Y:STATe ON|OFF
Turns the Y component of the digital video signal to on or off. You can use 1
or 0 instead of ON or OFF.
:OUTPut1:VIDeo:Y:STATe
Returns the current signal o utput state of the Y component of the digital video.
:OUTPut1:VIDeo:PB:STATe <ON|O FF>
Turns the P
B
component of the digital video signal to on or off. You can use 1
or 0 instead of ON or OFF.
:OUTPut1:VIDeo:PB:STATe?
Returns the current signal output state of the P
B
component of the digital video.
:OUTPut1:VIDeo:PR:STATe <ON|O FF>
Turns the P
R
component of the digital video signal to on or off. You can use 1
or 0 instead of ON or OFF.
:OUTPut1:VIDeo:PR:STATe?
Returns the current signal output state of the P
R
component of the digital video.
:OUTPut1:VIDeo:AVTiming <0|1>
Turns the output mode for an audio/video timing measurement on or
off. Refer to Operating Basics in the TG8000 User Manual for detailed
information about the mode. You can also use 1 or 0 instead of ON or OFF.
:OUTPut1:VIDeo:AVTiming?
Returns the current output mode setting for an audio/video timing
measurement.
:OUTPut1:VIDeo:EFILter:STA Te <0|1>
When set to 0, all edge filtering is disabled. Test signals with quick, large
data transitions will exhibit ringing.
:OUTPut1:VIDeo:EFILter:STA Te
Enabled = 1; Disabled = 0
:OUTPut1:VPID:STATe <0|1>
Sets the VPID (Video Payload IDentifier) state. 0 disables V PID. 1 enables
VPID.
:OUTPut1:VPID:STATe?
Returns the VPID state.
:OUTPut1:ZONE:FREQuency <NR1>
Sets the zone plate frequency.
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual 119