Tektronix TG8000

SDI7 Dual Channel SD/HD/3G SDI Video Generator module remote commands
Returns the Che
cksum value of the user-defined ancillary data packet.
:OUTPut<1|2>:ANC:CS:AUTO: STATe <Boolean>
Enables or disables the automatic Checksum calculation for the user-defined
ancillary data packet.
:OUTPut<1|2>:ANC:CS:AUTO: STATe?
Returns the state of the automatic Checksum calculation for the user-defined
ancillary data packet.
:OUTPut<1|2>:ANC:CS:AUTO?
Returns the automatically-calculated Checksum value for the user-defined
ancillary data packet.
:OUTPut<1|2>:ANC:VCH LUMA|CH RO
Sets the video channel for the location of the user-defined ancillary data
packet to either Luma or Chroma. LUMA is the default value. The command
is not necessary and has no effect for standard definition formats.
:OUTPut<1|2>:ANC:VCH?
Returns the video channel for the location of the user-defined ancillary data
packet.
:OUTPut<1|2>:ANC:LOCation LI NKA|LINKB
Sets
the virtual link for the location of the user-defined ancillary data packet.
This setting is only used for 3G-SDI formats.
:OU
TPut<1|2>:ANC:LOCation?
Returns the virtual link for the location of the user-defined ancillary data
pa
cket.
:OUTPut<1|2>:ANC:FIELd 0|1|2
Sets the field number for the location of the user-defined ancillary data packet.
This setting is only used for interlaced and segmented frame formats. Valid
values are: 0 = Field 1, 1 = Field 2, and 2 = both Field 1 & 2.
:OUTPut<1|2>:ANC:FIELd?
Returns the field number for the location of the user-defined ancillary data
packet.
:OUTPut<1|2>:BLACk <Boolean>
Draft
156 TG8000 Multiformat Test Signal Generator Programmer Manual