Tektronix TG8000 Programmer's Manual

SDI7 Dual Channel SD/HD/3G SDI Video Generator module remote commands
Returns the cir
cle overlay state for the selected generator output.
:OUTPut<1|2>:OVERlay:CIRCl e:DIAMeter <NR2>
Sets the diameter of the circle overlay for the selected generator output. The
value is expressed as a percentage of active picture height (%APH).
:OUTPut<1|2>:OVERlay:CIRCl e:DIAMeter?
Returns the diameter of the circle overlay for the selected generator o
utput.
:OUTPut<1|2>:OVERlay:CIRCl e:POSition:HORizontal <NR2>
Sets the horizontal position of the circle overlay for the selected generator
output. The circle overlay is drawn relative to center of the screen, with the
horizontal position value indicating the percentage of active picture width
(%APW) for the center of the circle.
A value of 0 indicates the horizontal center of the picture, -50.0 indicates the
left edge of the picture, and 50.
0 indicates the right edge of the picture.
:OUTPut<1|2>:OVERlay:CIRCl e:POSition:HORizontal?
Returns the horizontal center position of the circle overlay for the s elected
generator output.
:OUTPut<1|2>:OVERlay:CIRCl e:POSition:VERTical <NR2>
Sets the vertical position of the circle overlay of the selected generator output.
The circle overlay is drawn relative to center of the screen, with the vertical
position value indicating the percentage of active picture height (%APH)
for the center of the circle.
A value of 0 indicates the vertical center o f the picture, -50.0 indicates the top
edge of the picture, and 50.0 indicates the bottom edge of the picture.
:OUTPut<1|2>:OVERlay:CIRCl e:POSition:VERTical?
Returns the vertical center position of the ci
rcle overlay for the selected
generator output.
:OUTPut<1|2>:OVERlay:LOGO: STATe <Boolean>
Enables or disables the logo overlay for the selected generator output.
:OUTPut<1|2>:OVERlay:LOGO: STATe?
Returns the logo overlay s tate for the selected generator output.
:OUTPut<1|2>:OVERlay:LOGO: POSition:HORizontal <NR2>
Sets the horizontal position of the logo overlay for the selected generator
output. The logo overlay is drawn relative to the lower right corner of the
image, with the horizontal position value indicating the percentage of active
picture width (%APW) between the right edge of the logo image and the right
edge of the active picture. Values are less than or equal to 0.
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual 161

Tektronix TG8000 Specifications

General

Brand	Tektronix
Model	TG8000
Category	Portable Generator
Language	English