Tektronix TG8000 Programmer's Manual

SDI7 Dual Channel SD/HD/3G SDI Video Generator module remote commands
Returns the val
ue of the K
YT
parameter for the zone plate test pattern.
:OUTPut<1|2>:ZONE:KT <NR2>
Sets the value of the K
T
parameter ( temporal channel frequency) for the zone
plate test pattern.
:OUTPut<1|2>:ZONE:KT?
Returns the value of the K
T
parameter for the zone plate test pattern.
:OUTPut<1|2>:ZONE:KTSQ <NR2>
Sets the value of the K
T
2
parameter (temporal sweep) for the zone plate test
pattern.
:OUTPut<1|2>:ZONE:KTSQ?
Returns the value of the K
T
2
parameter for the zone plate test pattern.
:OUTPut<1|2>:ZONE:WAVE SINE| SQUARe|TRIAngle
Sets the waveform shape for the zone plate test pattern.
:OUTPut<1|2>:ZONE:WAVE?
Returns the current waveform shape for the zone plate test pattern.
:OUTPut<1|2>:ZONE:SAVE 1|2
Saves the current zone plate test pattern settings as Custom 1 or Custom
2. After saving, the full set of parameters can be restored with the
:SYNThesizer:SIGNal command using the ZP_1_CUSTOM, or ZP_2
CUSTOM parameter respectively.
:OUTPut<1|2>:ZONE:TRESet: STATe <Boolean>
Sets the temporal dimension for the zone plate test pattern to stay constant
or vary.
:OUTPut<1|2>:ZONE:TRESet: STATe?
Returns the temporal parameter state for the zone plate test pattern.
:OUTPut<1|2>:ZONE:VIDEO:Y :STATe <Boolean>
Enables or d isables the Y/G/X component of the zone plate test pattern,
depending on the selected sampling structure.
:OUTPut<1|2>:ZONE:VIDEO:Y :STATe?
Returns the Y/G/X component setting for the z one plate test pattern.
:OUTPut<1|2>:ZONE:VIDEO:P B:STATe <Boolean>
Enables or disables the P
B
/B/Y component of the zone plate test pattern,
depending on the selected sampling stru
cture.
:OUTPut<1|2>:ZONE:VIDEO:P B:STATe?
Draft
170 TG8000 Multiformat Test Signal Generator Programmer Manual

Tektronix TG8000 Specifications

General

Brand	Tektronix
Model	TG8000
Category	Portable Generator
Language	English