AVG7 Analog Video Generator module remote commands
:OUTPut1:LOGO
:POSition:HORizontal?
Returns the current horizontal position of the logo.
:OUTPut1:LOGO:POSition:VE RTical <numeric_value>
Sets the vertical position of the logo as it appears on the active signal. The
unit is the percent of active picture height. You can set the position from
-100% to 0% in 0.1% steps. You can also use MIN, MAX, or DEF instead of
anumericva
lue.
:OUTPut1:LOGO:POSition:VE RTical?
Returns the current vertical position o f the logo.
:OUTPut1:LOGO:SELect <logo_n ame>
Selects the logo used for the logo overlay.
:OUTPut1:LOGO:SELect?
Return
s the current logo used for the logo overlay.
:OUTPut1:LOGO:SAVe
Saves the current display position of the logo to the logo file. There are no
arguments.
:OUTPut1:TEXT:STATe ON|OFF
Turns the text overlay on the video signal on or off. You can use 1 or 0 instead
of ON or OFF.
:OUTPut1:TEXT:STATe?
Returns the current text overlay state.
:OUTPut1:TEXT:DATA <string>
Se
ts the current string for the text mode.
:OUTPut1:TEXT:DATA?
Returns the current string for the text mode.
:OUTPut1:TEXT:POSition:HO Rizontal <numeric_value>
Sets the text horizontal p osition in the video signal. The unit is the percent of
active picture width. You can set the position from 0% to 100% in 1% steps.
You can also use MIN, MAX, or DEF instead of the numeric value.
:OUTPut1:TEXT:POSition:HO Rizontal?
Returns the current text horizontal position in the video signal.
:OUTPut1:TEXT:POSition:VE RTical <numeric_value>
Draft
48 TG8000 Multiformat Test Signal Generator Programmer Manual
To Next Page
Loading...
