AVG7 Analog Video Generator module remote commands
Sets the text ve
rtical position in the video signal. The u nit is the percent of
active picture height. You can set the position from 0.0% to 100.0% in 1%
steps. You can also use MIN, MAX, or DEF instead of the numeric value.
:OUTPut1:TEXT:POSition:VER Tical?
Returns the current text vertical position in the video signal.
:OUTPut1:TEXT:SAVe
Saves the current text and its display position to the signal file. There are
no arguments.
:OUTPut1:OVERlay:BLINk:STA Te ON|OFF
Turns on or off the blinking mode for the logo, text, and circle overlay. You
canalsouse1or0insteadofONorOFF.
:OUTPut1:OVERlay:BLINk:STA Te?
Returns the current state of the blinking mode for the logo, text, and circle
overlay.
:OUTPut1:OVERlay:BLINk:PER iod <numeric_value>
Sets the blinking interval of the b linking mode for the logo, text, and circle
overlay. You can set the value as 0.5 seconds or 1.0 seconds.
:OUTPut1:OVERlay:BLINk:PER iod?
Returns the blinking interval of the blinking mode for the logo, text, and
circle overlay.
:OUTPut1:APL:MODe APL_OFF|APL _HIGH|APL_LOW|APL_BOUNCE|BOUNCE
Sets the output mode of the APL signal. Refer to the APL Submenu section in
the TG8000 User Manual for detailed information about the each mode.
:OUTPut1:APL:MODe?
Returns the current output mode of the APL signal.
:OUTPut1:APL:PERiod <numeric_ value>
Sets the time interval between two signals when they are output in the bounce
modes. You can set the value from 0.5 seconds to 2.0 seconds in 0.5 seconds
steps.
:OUTPut1:APL:PERiod?
Returns the time interval between two signals when they are output in the
bounce modes.
:OUTPut1:MOVe:HORizontal <num eric_value>
Sets the amount of horizontal scrolling in the moving picture mode. You can
setthevaluefrom-252to+252in4samplessteps.
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual 49
To Next Page
Loading...
Need help?
General
