AVG7 Analog Video Generator module remote commands
:OUTPut1:MOVe
:HORizontal?
Returns the amount of horizontal scrolling in the moving picture mode.
:OUTPut1:MOVe:VERTical <nume ric_value>
Sets the amount of vertical scrolling in the moving picture mode. You can set
the value from -252 to +252 in 1 line steps.
:OUTPut1:MOVe:VERTical?
Returns the amount of vertical scrolling in the moving picture mode.
:OUTPut1:MOVe:PERiod <numeri c_value>
Sets the time interval between occurrences of the scrolling. You can set the
value from 1 to 16 in 1 field steps.
:OUTPut1:MOVe:PERiod?
Returns the time interval between occurrences of the scrolling.
:OUTPut1:MOVe:RANDom:STAT e ON|OFF
Turns the random scrolling mode on or off. You can also use 1 or 0 instead of
ON or OFF.
:OUTPut1:MOVe:RANDom:STAT e?
Returns the current state of the random scrolling m ode.
:OUTPut1:VIDeo:CONFig YC|COM POSITE
Sets the output channel configuration when a composite signal is being output.
For YC, a Y signal, C signal, and composite signal will be assigned to CH1,
CH2, and CH3 respectively. For COMPOSITE, a composite signal will be
assigned to all the three channels.
:OUTPut1:VIDeo:CONFig?
Returns the current setting of the output channel configuration when a
composite signal is being output.
:OUTPut1:VIDeo:SCH <numeric_ value>
Sets the SCH phase for a composite signal. You can set the value from -180
degrees to +180 degrees in 1 degree steps.
:OUTPut1:VIDeo:SCH?
Returns the current SCH phase setting.
:OUTPut1:VIDeo:SYNC:STATe ON |OFF
Sets whether or not a sync signal is multiplexed with the B and R signals when
a GBR signal is being output. You can also use 1 or 0 instead of ON or OFF.
:OUTPut1:VIDeo:SYNC:STATe ?
Draft
50 TG8000 Multiformat Test Signal Generator Programmer Manual
To Next Page
Loading...
Need help?
General
