AWVG7 Analog Wideband Video Generator module remote c ommands
:OUTPut1:TEXT
:SAVe
Saves the current text and its display position to the signal file. There are
no argum
ents.
:OUTPut1:OVERlay:BLINk:STA Te ON|OFF
Turns on or off the blinking mode for the logo, text, and circle overlay. You
canalsouse1or0insteadofONorOFF.
:OUTPut1:OVERlay:BLINk:STA Te?
Returns the current state of the blinking mode for the logo, text, and circle
overlay.
:OUTPut1:OVERlay:BLINk:PER iod <numeric_value>
Sets the blinking interval of the b linking mode for the logo, text, and circle
overlay. You can set the value as 0.5 seconds or 1.0 seconds.
:OUTPut1:OVERlay:BLINk:PER iod?
Returns the blinking interval of the blinking mode for the logo, text, and
circle overlay.
:OUTPut1:MOVe:HORizontal <num eric_value>
Sets the amount of horizontal scrolling in the moving picture mode. You can
setthevaluefrom-252to+252in4samplessteps.
:OUTPut1:MOVe:HORizontal?
Returns the amount of horizontal scrolling in the moving picture mode.
:OUTPut1:MOVe:VERTical <numer ic_value>
Sets the amount of vertical scrolling in the moving picture mode. You can set
thevaluefrom-252to+252in1linesteps.
:OUTPut1:MOVe:VERTical?
Returns the amount of vertical scrolling in the moving picture mode.
:OUTPut1:MOVe:PERiod <numeric _value>
Sets the time interval between occurrences of the scrolling. You can set the
value from 1 to 16 in 1 field steps.
:OUTPut1:MOVe:PERiod?
Returns the time interval between occurrences of the scrolling.
:OUTPut1:MOVe:RANDom:STATe ON |OFF
Turns the random scrolling mode on or off. You can also use 1 or 0 instead of
ON or OFF.
:OUTPut1:MOVe:RANDom:STATe ?
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual 57
To Next Page
Loading...
Need help?
General
