AWVG7 Analog Wideband Video Generator module remote commands
Sets the vertic
al position of the logo as it appears on the active signal. The
unit is the percent of active picture height. You can set the position from
-100% to 0% in 0.1% steps. You can also use MIN, MAX, or DEF instead of
a numeric value.
:OUTPut1:LOGO:POSition:VE RTical?
Returns the current vertical position o f the logo.
:OUTPut1:LOGO:SELect <logo_n ame>
Selects the logo used for the logo overlay.
:OUTPut1:LOGO:SELect?
Returns the current logo used for the logo overlay.
:OUTPut1:LOGO:SAVe
Saves the current display position of the logo to the logo file. There are no
arguments.
:OUTPut1:TEXT:STATe ON|OFF
Turns the text overlay on the video signal on or off. You can use 1 or 0 instead
of ON or OFF.
:OUTPut1:TEXT:STATe?
Returns the current text overlay state.
:OUTPut1:TEXT:DATA <string>
Sets the current string for the text mode.
:OUTPut1:TEXT:DATA?
Returns the current string for the text mode.
:OUTPut1:TEXT:POSition:HO Rizontal <numeric_value>
Sets the text horizontal p osition in the video signal. The unit is the percent of
active picture width. You can set the position from 0% to 100% in 1% steps.
You can also use MIN, MAX, or DEF instead of the numeric value.
:OUTPut1:TEXT:POSition:HO Rizontal?
Returns the current text horizontal position in the video signal.
:OUTPut1:TEXT:POSition:VE RTical <numeric_value>
Sets the text vertical position in the video signal. The u nit is the percent of
active picture height. You can set the position from 0% to 100% in 1% steps.
You can also use MIN, MAX, or DEF instead of the numeric value.
:OUTPut1:TEXT:POSition:VE RTical?
Returns the current text vertical position in the video signal.
Draft
56 TG8000 Multiformat Test Signal Generator Programmer Manual
To Next Page
Loading...
Need help?
General
