BG7 Black Generator module remote commands
With Option CB y
ou can also select:
CB100PER (100% color bars), CB75PER (75% color bars) CB_100_OR
(100% color bars over red), CB_75_OR (75% color bars over red),
FF40PER (40% flat field), OTHER_ONE (Other 1), or OTHER_TWO
(Other 2).
:OUTPut<n>:SIGNal?
Returns the current output signal. The <n> in the command represents the
connector number. You can use any co
nnector number from 1 through 4.
:OUTPut4:TIMECode:STATus?
Returns the current time code settings.
:OUTPut4:TIMECode:SOURce DIS able|TOD|COUNter
Sets time code source. Disable shuts off the time code output. TOD sets
the time of day clock as the source. Counter sets the time c ode source to
the program counter. See the GPS7 Synchronization a nd Timecode Module
Remote Commands chapter, starting on page 2-92 for more information on
the TOD setting.
:OUTPut4:TIMECode:SOURce?
Returns the current time code source setting.
:OUTPut4:TIMECode:OFFSet <NR 1>,<NR1>,<NR1>,<NR1>
Sets the time code offset in hours, minutes, seconds, and frames
(HH:MM:SS:FF).
:OUTPut4:TIMECode:VITc[1/ 2]:STATe 0 | 1 (BOOLEAN)
Enables or disables the insertion of a VITC. You can enable two time codes.
Setting the state to 1 enables the time code. Setting the state to 0 disables
the time code.
:OUTPut4:
TIMECode:LINe <NR1>
Sets the line number on which the VITC is located. For NTSC output, the line
number range is 10-20. For PA L output, the line number range is 6-22. For
HD output, the line number range is 7 -40.
:OUTPut4:TIMECode:LINe?
Returns the line number on which the VITC is located.
:OUTPut4:TIMECode:DROPf:STATe0|1(BOOLEAN)
Enables or disables the use of Drop Frame time code.
:OUTPut4:TIMECode:DROPf:S TATe?
Returns the Drop Frame time code state. A setting of 0 means drop frame
time code is not used. A setting o f 1 means drop frame time code is used.
Draft
62 TG8000 Multiformat Test Signal Generator Programmer Manual
To Next Page
Loading...
Need help?
General
