Tektronix TG8000 Programmer's Manual

DVG7 Digital Video Generator module remote commands
Sets the amplit
ude of a specific embedded audio channel for the selected
outputs. You can set the amplitude from -60 dBFS to 0 dBFS in 1 dBFS steps.
The <n> in the command represents the output connector type. "1" represents
the SIGNAL connectors and "2" represents the optional BLACK connectors.
The <m> in the command represents the channel number and you can use any
channel number from 1 through 16.
:OUTPut<n>:EAUDio:CHANnel <m>:AMPLitude?
Returns the current amplitude of a specific embedded audio channel for the
selected outputs. The <n> in the command represents the output connector
type. "1" represents the SIGNAL connectors and "2" represents the optional
BLACK con
nectors. The <m> in the command represents the channel number
and you can use any channel number from 1 through 16.
:OUTPut
<n>:EAUDio:CHANnel<m>:FREQue ncy <numeric_value>
Sets the frequency of a specific embedded audio channel for the selected
output
s. The frequency choices are -1, 0, 50, 100, 150, 200, 250, 300, 400,
500, 600, 750, 800, 1000, 1200, 1500, 1600, 2000, 2400, 3000, 3200, 4000,
4800, 5000, 6000, 8000, 9600, 10000, 12000, 15000, 16000, or 20000. For -1,
the output of the audio data is disabled. The <n> in the command represents
the output connector type. "1" represents the SIGNAL connectors a nd "2"
represents the optional BLACK connectors. The <m> in the command
repr
esents the channel number and you can use any channel number from 1
through 16.
:OU
TPut<n>:EAUDio:CHANnel<m>: FREQuency?
Returns the current frequency of a specific embedded audio channel for the
se
lected outputs. The <n> in the command represents the output connector
type. "1" represents the SIGNAL connectors and "2" represents the optional
BLACK connectors. The <m> in the command represents the channel number
and you can use any channel number from 1 through 16.
:OUTPut<n>:EAUDio:CHANnel <m>:CLICk 0|1|2|3|4
Sets the audio click of a specific audio channel for the selected outputs. You
can select 0, 1 (second), 2 (seconds), 3 (seconds) or 4 (seconds). When 1, 2, 3
or 4 is selected, the audio click becomes valid. Audio Tone is turned off for
0.25 seconds around the time of the click. The <n> in the command represents
the output connector type. "1" represents the SIGNAL connectors a nd "2"
represents the optional BLACK connectors. The <m> in the command
represents the channel number and you can use any channel number from 1
through 16.
:OUTPut<n>:EAUDio:CHANnel <m>:CLICk?
Draft
68 TG8000 Multiformat Test Signal Generator Programmer Manual

Tektronix TG8000 Specifications

General

Brand	Tektronix
Model	TG8000
Category	Portable Generator
Language	English