DVG7 Digital Video Generator module remote commands
Returns the cur
rent output state of the Y component of the serial digital video
signals.
:OUTPut1:VIDeo:PB:STATe ON|OF F
Turns the P
B
component of the serial digital video signals on or off. You can
also use 1 or 0 instead of ON or OFF.
:OUTPut1:VIDeo:PB:STATe?
Returns the current output state of the P
B
component of the serial digital video
signals.
:OUTPut1:VIDeo:PR:STATe ON|OF F
Turns the P
R
component of the serial digital video signals on or off. You can
also use 1 or 0 instead of ON or OFF.
:OUTPut1:VIDeo:PR:STATe?
Returns the current output state of the P
R
component of the serial digital video
signals.
:OUTPut<n>:VIDeo:NBITs 8|10
Sets the video resolution for the selected output. The options are 8 bits or 10
bits. The <n> in the command represents the output connector type. "1"
represents the SIGNAL connectors and "2" represents the optional BLACK
connectors.
:OUTPut<n>:VIDeo:NBITs?
Returns the current video resolution for the selected outputs. The options are
8 bits or 10 bits. The <n> in the command represents the output connector
type. "1" represents the SIGNAL connec
tors and "2" represents the optional
BLACK connectors.
:OUTPut<n>:VIDeo:EDH:STATe ON |OFF
Turns Error Detection and Handling insertion for the selected outputs on
or off. The <n> in the command represents the output connector type. "1"
represents the SIGNAL connectors and "2" represents the optional BLACK
connectors.
:OUTPut1:VIDeo:EDH:STATe?
Returns the current Error Detection and Handling insertion status.
:OUTPut<n>:VIDeo:EDH:STATe ?
Returns the current Error Detection and Handling insertion status for the
selected outputs. The <n> in the command represents the output connector
type. "1" represents the SIGNAL connectors and "2" represents the optional
BLACK connectors.
:OUTPut1:VIDeo:AVTiming:ST ATe ON|OFF
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual 73
To Next Page
Loading...
Need help?
General
