DVG7 Digital Video Generator module remote commands
:OUTPut1:OVER
lay:BLINk:PERiod <numeric_value >
Sets the b linking interval of the blinking mode for the logo, text, and circle
overlay
. You can set the value as 0.5 seconds or 1.0 seconds.
:OUTPut1:OVERlay:BLINk:PE Riod?
Returns the blinking interval of the blinking mode for the logo, text, and
circle overlay.
:OUTPut1:TEXT:STATe ON|OFF
Turns the text overlay display on the video signal on or off. You can also use
1or0insteadofONorOFF.
:OUTPut1:TEXT:STATe?
Returns the current text overlay state.
:OUTPut1:TEXT:DATA <string>
Sets the current string for the text mode.
:OUTPut1:TEXT:DATA?
Returns the current string for the text mode.
:OUTPut1:TEXT:POSition:HO Rizontal <numeric_value>
Sets the text horizontal position in the video signal. The unit is percent of
active picture width. You can set the position from 0% to 100% in 1% steps.
You can also use MIN, MAX, or DEF instead of the numeric value.
:OUTPut1:TEXT:POSition:HO Rizontal?
Returns the current text horizontal position in the video signal.
:OUTPut1:TEXT:POSition:VE RTical <numeric_value>
Sets the text vertical position in the video signal. The unit is percent of active
picture height. You can set the position from 0% to 100% in 1% steps. You
can also use MIN, MAX, or DEF instead of the numeric value.
:OUTPut1:TEXT:POSition:VE RTical?
Returns the current text vertical position in the video signal.
:OUTPut1:TEXT:SAVe
Saves the current text and its display position to the signal file. There are
no arguments.
:OUTPut1:VIDeo:Y:STATe ON|OF F
Turns the Y component of the serial digital video signals on or off. You can
also use 1 or 0 i nstead of ON or OFF.
:OUTPut1:VIDeo:Y:STATe?
Draft
72 TG8000 Multiformat Test Signal Generator Programmer Manual
To Next Page
Loading...
Need help?
General
