DVG7 Digital Video Generator module remote commands
:OUTPut1:LOGO
:SELect <logo_name>
Selects the logo used for the logo overlay.
:OUTPut1:LOGO:SELect?
Returns the current logo used for the logo overlay.
:OUTPut1:LOGO:SAVe
Saves the current display position of the logo to the logo file. There are no
arguments.
:OUTPut1:MOVe:HORizonta
l <numeric_value>
Sets the amount of horizontal scrolling in the moving picture mode. You can
setthevaluefrom-252to+252in4samplessteps.
:OUTPut1:MOVe:HORizontal?
Returns the amount of horizontal scrolling in the moving picture mode.
:OUTPut1:MOVe:VERTical <numer ic_value>
Sets the amount of vertical scrolling in the moving picture mode. You can set
thevaluefrom-252to+252in1linesteps.
:OUTPut1:MOVe:VERTical?
Returns the amount of vertical scrolling in the moving picture mode.
:OUTPut1:MOVe:PERiod <numeric _value>
Sets the time interval between occurrences of the scrolling. You can set the
value from 1 to 16 in 1 field steps.
:OUTPut1:MOVe:PERiod?
Returns the time interval between occurrences of the scrolling.
:OUTPut1:MOVe:RANDom:STATe ON |OFF
Turns the random scrolling mode on or off. You can also use 1 or 0 instead of
ON or OFF.
:OUTPut1:MOVe:RANDom:STATe ?
Returns the current state of the random scrolling mode.
:OUTPut1:OVERlay:BLINk:STA Te ON|OFF
Turns on or off the blinking mode for the logo, text, and circle overlay. You
canalsous
e 1 or 0 instead of ON or OFF.
:OUTPut1:OVERlay:BLINk:STA Te?
Returns the current state of the blinking mode for the logo, text, and circle
overlay.
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual 71
To Next Page
Loading...
Need help?
General
