GPS7 GPS Synchronization and Timecode module remote commands
:SOURce:TIMES
et:TOD:SOURce INTernal | GPS | VITc | LTC
NOTE. The arguments VITc and LTC are not supported by GPS7 modules that do
not have a REF IN connector.
Sets the source for the mainframe time of day.
:SOURce:TIMESet:TOD:SOURce ?
Returns the source setting for the mainframe time of day.
:SOURce:TIMESet:TOD:TIME
<numeric_value>,<numeric_v alue>,<numeric_value> (HH:MM:SS)
Sets the global mainframe time of day. This setting has no effect if the TOD
source is set to GPS.
:SOURce:TIMESet:TOD:TIME?
Returns the global mainframe time of day.
:SOURce:TIMESet:TOD:DATE
<numeric_value>,<numeric_v alue>,<numeric_value> (YYYY:MM:DD)
Sets the global mainframe date.
:SOURce:TIMESet:TOD:DATE?
Returns the global mainframe date.
:SOURce:TIMESet:TOD:MODE FOLL ow | ONCE | NO
W
NOTE. This command is not supported by GPS7 modules that do not have a REF
IN connector.
Sets the timecode synchronization method for VITC. Select FOLLow to
continually synchronize the timecode. Select ONCE to synchronize the
timecode only once when lock is achieved.
Select NOW to synchronize the
timecode when the EXECute c ommand is set.
:SOURce:TIMESet:TOD:MODE:E XECute
NOTE. This command is not supported by GPS7 modules that do not have a REF
IN connector.
Initiates an immediate timecode synchronization.
:SOURce:TIMESet:AUTO:STATe OF F | ONCE | RECUR
Sets the automatic time offset function.
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual 85
To Next Page
Loading...
Need help?
General
