Section D – Tester Installation
CD14 Tester & CD AutoPlus Autosampler User Guide—75-108-800 Rev. B—31 May 2021 33 of 130
EAR99 technology subject to restrictions on cover page.
5. Insert the external temperature probe into the fitting
located adjacent to the mast in the vessel plate.
6. After all connections have been made to the heater,
gently slide the heater box all the way back as far as
it will go. The tubes may need some guidance as
this is done so they go straight back and are over
the cable bundle.
7. With the drive plate assembly raised all the way up,
reach over the vessel plate (if there is no clearance
on the sides) to connect both sets of water
circulation tubes to the quick-disconnect fittings on
the back of the bath.
To Next Page
Loading...
